Just imagine pulling up to your best friend's place or a car show with your own beast to show off! Over 600,000 Fans!

Posts tagged: Blueprint Engines

383 Chevy vs. 383 Mopar!

It’s our first head-to-head shootout with two engines: a Blueprint Engines crate Chevy 383 small-block versus a hand-built Mopar 383 by Engine Masters host Steve Dulcich. To make this a fair test, we equalized as many variables as possible: both engines use the same carburetor and the same type of ignition, intake manifold, camshaft, compression

Read More

The post 383 Chevy vs. 383 Mopar! appeared first on Muscle Car Fan.

Read more

Dyno Proven: 50 HP With One Bolt-On!

Engine Masters, presented by AMSOIL, is an all-new show for the Motor Trend channel! Each episode takes you into the engine-dyno room where power claims are questioned and head-to-head shootouts ensue. Engine Masters finds the truth about speed parts and has a lot of fun doing it with hosts David Freiburger of HOT ROD and

Read More

The post Dyno Proven: 50 HP With One Bolt-On! appeared first on Muscle Car Fan.

Read more

383 Chevy vs. 383 Mopar! – Engine Masters

It’s our first head-to-head shootout with two engines: a Blueprint Engines crate Chevy 383 small-block versus a hand-built Mopar 383 by Engine Masters host Steve Dulcich. To make this a fair test, we equalized as many variables as possible: both engines use the same carburetor and the same type of ignition, intake manifold, camshaft, compression

Read More

The post 383 Chevy vs. 383 Mopar! – Engine Masters appeared first on Muscle Car Fan.

Read more

Holley vs. Edelbrock, Tri-Power vs. Dual-Quad!

Dual quads! Three deuces! Eight barrels! Six jugs! The lore of multiple carburetors runs deep in the hot rodding world, and in the muscle car era it was common for the OE manufacturers to up their cars’ performance and image with either two four-barrel carburetors (a dual-quad, or eight-barrel) or three two-barrel carbs (known at

Read More

The post Holley vs. Edelbrock, Tri-Power vs. Dual-Quad! appeared first on Muscle Car Fan.

Read more

Exhaust Header Bash! Testing Power Loss From Dents

If you’ve ever installed a set of high-performance exhaust headers, then you’ve probably bashed those exhaust tubes with a hammer to get them to clear everything in the chassis of the car. It’s a super common problem, but people often worry about how much horsepower they are killing by dinging and denting those headers. This

Read More

The post Exhaust Header Bash! Testing Power Loss From Dents appeared first on Muscle Car Fan.

Read more